Wenko 4478010100 Right Angle Hooks User Manual

1. Sarrera

Thank you for choosing the Wenko 4478010100 Right Angle Hooks. This set of four rust-free stainless steel adhesive hooks is designed for versatile use in various areas of your home, including bathrooms and kitchens. Their self-adhesive backing allows for easy installation without the need for drilling.

2. Segurtasun informazioa

• Ensure the installation surface is clean, dry, and smooth for optimal adhesion.
• Do not exceed the maximum weight recommendation of 37 pounds (approximately 16.7 kg) per hook.
• Avoid installing hooks on delicate or easily damaged surfaces, as removal may cause damage.
• Keep out of reach of children to prevent accidental ingestion of small parts or injury.

3. Konfigurazioa eta instalazioa

Follow these steps for proper installation of your Wenko Right Angle Hooks:

1. Prestatu gainazala: Select a smooth, clean, and dry surface for installation. Thoroughly clean the area with a suitable cleaner and ensure it is completely dry before proceeding.
2. Kendu film babeslea: Carefully peel off the protective film from the adhesive backing of the hook.
3. Posizioa eta Prentsa: Position the hook firmly against the desired surface. Apply strong, even pressure for at least 30 seconds to ensure a secure bond.
4. Onartu itsaspen-denbora: For best results, allow the adhesive to cure for 24 hours before hanging any items on the hook. This ensures maximum holding strength.

Image 1: Wenko Right Angle Hooks installed on a wall, demonstrating typical usage with a towel.

4. Funtzionamendu-argibideak

Once installed and the adhesive has cured, the Wenko Right Angle Hooks are ready for use. Simply hang items such as towels, robes, kitchen utensils, or other lightweight objects on the hook. Ensure the weight of the item does not exceed the maximum recommended load.

5. Mantentzea

To maintain the appearance and functionality of your stainless steel hooks:

• Garbitu aldizka zapi leun batekin,amp oihal.
• For stubborn marks, use a mild stainless steel cleaner and wipe dry immediately.
• Avoid abrasive cleaners or scouring pads, as these can scratch the matt finish.

6. Arazoak

Hook is not adhering properly:

• Ensure the surface was thoroughly cleaned and dried before application. Grease, dust, or moisture will prevent proper adhesion.
• Verify the surface is smooth and non-porous. Adhesive hooks may not work effectively on textured or porous surfaces.
• Confirm sufficient pressure was applied during installation and the recommended curing time (24 hours) was observed before use.
• If the adhesive is compromised, the hook may need to be replaced.

Hook falls off after some time:

• Check if the weight of the hung item exceeds the maximum weight recommendation of 37 pounds.
• Environmental factors like high humidity or extreme temperature changes can affect adhesive performance over time.

7. Zehaztapenak

Image 2: Dimensional diagram of the Wenko Right Angle Hook.

8. Bermea eta Laguntza

For warranty information or product support, please refer to the official WENKO webwebgunera edo jarri harremanetan zuzenean bezeroarentzako arreta-zerbitzuarekin. Gorde erosketa-agiria erosketaren frogagiri gisa.

WENKO Official Webgunea: www.wenko.com