FABER BACK Series BACKSPLASH Kit Instruction
PIEZAK
- backsplash
- Pozi Screws (Screws 3/16″ x 1-15/16″)
- Hormako tapoia (3/16″ x 2-3/4″)
DIMENSION
INSTALAZIOA
ADI! The backsplash should be installed before the hood is installed.
- Position the lower section of backsplash on the wall. Center it side to side and markthe mounting holes. Remove the lower section from the wall.
- Attach the lower section of the backsplash to the wall with the 6 screws (G) provided.
- Position the upper section of the backsplash on the wall. The top position of the upper section should be at least 1” above the bottom of the hood so the recessed screws are covered. Center it side to side and mark the holes. Remove the upper section from the wall.
- Peel off the double-sided tape. Attach the upper section to the wall with 3 screws (G) provided.
- Press the upper section to the lower section to make sure the tape fully adheres tothe lower section.
ALTZAIRU INOXIDABLEA GARBITZEA
Kanpoko gainazalak garbitzea
Kontuan izan, urratzaile eta zikindu-agenteek barruko kanpaiaren akaberak urratu ditzakete eta ez dira erabili behar amaitutako gainazalak garbitzeko.
Stainless Steel finish cleaning instructions
Garbitu kanpoko gainazalak merkataritzan eskuragarri dagoen altzairu herdoilgaitzezko garbitzaile batekin.
991.0682.077_01 – 220524 D000000008732_00
Dokumentuak / Baliabideak
 |
FABER BACK Series BACKSPLASH Kit [pdf] Argibide eskuliburua BACK30, BACK36, BACK48, BACK Series BACKSPLASH Kit, BACK Series, BACKSPLASH Kit, BACKSPLASH |
