TWS Bluetooth entzungailuak
INSTRUCTION
SEGURTASUN KONTUZ
- Use earbuds while driving, please observe the national and regional regulation.
- Please put all the equipment and accessories can not be touched by the child or pet, which may cause suffocation and serious consequences.
- Please don’t use the product under too high or too low temperature environment. (Below -10 degree centigrade or Above- 45 degree centigrade)
- Extreme temperatures can cause deformations, reduce the charging capacity of the device, and shorten the service life.
- Do not use wet equipment, liquid which can cause severe damage to equipment.
- Please do not use wet hand operating equipment, equipment damage caused by water does not under the warranty scope.
- If the earbuds play at high volume for a long time, your hearing may be hurt and suggest using the lowest volume of the phone.
TWS OPERATION INSTRUCTIONS
Initial Earbuds Set Up/Pairing
-
- Step 1: Once both earbuds are removed from the case they will automatically power on, blue light on each earbud will be on.
- Step 2: Once the earbuds are turned on wait for the prompt “DuDu”, this confirms that the earbuds are synced. Once pairing between 2 earbuds, a blue and red light will start to flash in the left earbud and a blue light flash in the right earbud.
- Step 3: Go to the Bluetooth connection list on your smart phone or tablet and search for “T31R” Bluetooth name on your device. Click to connect. Both earbuds flash blue light indicating that the earbuds are connected to the Bluetooth device.
- Step 1: Once both earbuds are removed from the case they will automatically power on, blue light on each earbud will be on.
TWS OPERATION INSTRUCTIONS
- Pizte automatikoa: Once both earbuds are removed from the case they will automatically power on, a blue light on each earbud will on about 1 second, a blue light of the left one will have 3 flashes at a time and the connection process will start.
- Eskuzko piztea: Press and hold the main button on the
earbud at the same time for about 3 seconds to power on. A blue light will on and begin to flash on the earbuds followed by a “Power On” message through the earbuds. - Auto itzaltzea: Place the earbuds back into the case and close the lid. Once they are put into the case, they will automatically power off and enter into the charged state when a red light flashing on each earbud.
- Eskuz itzali Press and hold the main button on the earbud at the same time for about 3 seconds to power off. A blue light will on and begin to flash on the earbuds followed by a “Power Off” message through the earbuds.
- Musika Erreproduzitu / Pausatu： Short press button could play or pause music playing.
- Music Next/Previous: Double press the main button of earbud to go to the next song. Double press the main button of earbud to go to the previous song.
- Answer Call： During incoming call, once press the main button of earbud once to answer a call.
- Amaitu deia: During a call, once press the main button of earbud to end a call.
- Reject Call：During an incoming call, double-press the main button of earbud to reject a call.
- Cancel Call：During the dialing state, once press or button to cancel a call.
- Low Battery Clarm：When the earbuds’ power is less than 20%, they flash a red light and follow by a “Low Battery” message through the earbuds.
- Low Battery Shutdown： When the earbuds run out of battery power, they will automatically shut off.
- Automatic Connection：After the initial set up and connection the earbuds will automatically connect to your device next time you turn them on. (Please ensure the Bluetooth is active on your device for automatic connection.)
- Restore Original Settings : Under power off status, press and hold the buttons for about 10 seconds, both earphones can be restored to Factory Settings with alternating red and blue lights flashing on both earbuds . Then the earbuds can be reused by auto or manually power on/off.
- Aurikularretarako kargatzen Jarri earbuds into the Charging Cases and close the lid to start the charging process.The charging earbuds will flash red lights until fully charged. Once fully charged the red light will turn off.
Case Power Indicator 
TEKNIKOAK
| Bluetooth bertsioa | V5.0 |
| Bluetooth Distantzia | 10-15M |
| Entzungailuen bateria | 50mAh * 2 |
| Kargatzeko Case Bateria | 400mAh |
| Denbora kargatu | Ordubete inguru |
| Musika jolasteko ordua | 5 ordu inguru |
| Calling Talk Time | 5 ordu inguru |
| Egonean denbora | 200 ordu |
FCC
Gailu honek FCC Arauen 15. zatia betetzen du. Funtzionamendua honako bi baldintza hauen menpe dago:
- gailu honek ezin du interferentzia kaltegarririk eragin eta
- gailu honek jasotako interferentziak onartu behar ditu, nahi ez diren eragiketak sor ditzakeen interferentziak barne.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: –
- Antena hartzailea berriro orientatu edo lekuz aldatu.
- Handitu ekipoaren eta hargailuaren arteko bereizketa.
- Konektatu ekipoa hargailua konektatuta dagoen zirkuitu bateko hartune batera.
- Laguntza lortzeko, kontsultatu saltzaileari edo esperientziadun irrati / telebistako teknikariari
FAQS
Is TWS Bluetooth earbuds good?
All in all, just don’t expect true wireless earbuds to pack a superior sound as similarly priced regular wireless earbuds. Yes, they’re pricier, but in this case, the additional money does not translate to better performance.
Is TWS better than Airpods?
While both headphones are comfortable, the Apple are better-built, have a more neutral sound profile, which some users may prefer, and a significantly better noise isolation performance.
Does TWS have noise Cancelling?
Oppo Enco Buds Bluetooth True Wireless in Ear Earbuds(TWS) with Mic, 24H Battery Life, Supports Dolby Atmos Noise Cancellation During Calls, IP54 Dust & Water Resistant,(Blue, True Wireless)
Is TWS Bluetooth earbuds good?
All in all, just don’t expect true wireless earbuds to pack a superior sound as similarly priced regular wireless earbuds. Yes, they’re pricier, but in this case, the additional money does not translate to better performance.
What is the battery life of TWS?
TWS earbuds typically have a battery life of 3 hours or less before they run out of juice. Charger cases come in handy in this situation. A good charging case can extend the listening period of your earbuds by at least 18 to 20 hours.
Q: What should I do if the earbuds get wet?
A: Do not use wet equipment, liquid which can cause severe damage to equipment.
G: Nola parekatu ditzaket entzungailuak nire gailuarekin?
A: First, remove both earbuds from the case and wait for the prompt “DuDu.” Then, go to the Bluetooth connection list on your device and search for “T31R” Bluetooth name. Click to connect.
Q: How do I turn on the earbuds?
A: You can either use the auto power on feature by removing both earbuds from the case, or manually power on by pressing and holding the main button on the earbud for about 3 seconds.
G: Nola jakin dezaket entzungailuak guztiz kargatuta daudenean?
A: The charging earbuds will flash red lights until fully charged. Once fully charged, the red light will turn off.
Q: How long does it take to charge the earbuds?
A: It takes about 1.5 hours to fully charge the earbuds.
G: Zenbat irauten du bateriak?
A: The earbuds have a music playing time of about 5 hours and a calling talk time of about 5 hours.
Q: How do I play or pause music?
A: Short press the button on the earbud to play or pause music playing.
Q: How do I answer or end a call?
A: During an incoming call, press the main button of the earbud once to answer a call. During a call, press the main button of the earbud once to end a call.
Q: How do I reject a call?
A: During an incoming call, double-press the main button of the earbud to reject a call.
Q: How do I cancel a call?
A: During the dialing state, press either button to cancel a call.
Q: How do I restore the earbuds to factory settings?
A: Under power off status, press and hold the buttons for about 10 seconds. Both earphones can be restored to factory settings with alternating red and blue lights flashing on both earbuds. Then the earbuds can be reused by auto or manually power on/off.
