Zippo 45016 Digital Quartz Watch

Sarrera

Thank you for choosing the Zippo 45016 Digital Quartz Watch. This manual provides detailed instructions to help you understand and operate your new watch effectively. Please read this manual thoroughly before use and keep it for future reference.

Segurtasun Informazioa

• Ez saiatu erlojuaren kaxa irekitzen edo bateria ordezkatzen zeuk, bermea baliogabetu eta erlojua kaltetu baitezake.
• Saihestu erlojua tenperatura altuen, eguzki-argiaren eraginpean denbora luzez edo eremu magnetiko indartsuen eraginpean jartzea.
• Clean the watch with a soft, dry cloth. Do not use chemical cleaners.
• While the watch is designed for daily wear, avoid direct impact or dropping it.

Konfigurazioa

Initial Power-On and Time Setting

Your Zippo 45016 watch comes with a pre-installed battery. Upon first use, you may need to set the current time and date.

1. Locate the mode button (usually on the bottom left) and the adjustment buttons (usually on the right side).
2. Press the mode button repeatedly until the time setting mode is displayed. Digits for hours or minutes will typically flash.
3. Use the adjustment buttons (e.g., 'Start/Stop' or 'Reset') to increase or decrease the flashing value.
4. Sakatu berriro modu botoia hurrengo ezarpenera joateko (minutuak, urtea, hilabetea, eguna).
5. Once all settings are correct, press the mode button one last time to exit the setting mode.

Image: Zippo 45016 Digital Quartz Watch. This image shows the watch face and strap, illustrating its general appearance and button placement for setup and operation.

Funtzionamendu-argibideak

Oinarrizko denboraren bistaratzea

In the default mode, the watch displays the current time (hours, minutes, seconds) and often the day of the week and date.

Argi-funtzioa

Argi gutxiko baldintzetan pantaila argiztatzeko:

• Press the 'Light' button (typically located on the top left or top right of the watch).
• The backlight will activate for a few seconds.

Lap Timer (Stopwatch) Function

The lap timer allows you to measure elapsed time.

1. Press the 'Mode' button until the stopwatch display appears (usually indicated by 'STW' or a stopwatch icon).
2. Press the 'Start/Stop' button (often on the top right) to begin timing.
3. To record a lap time without stopping the main timer, press the 'Lap' or 'Reset' button. The lap time will display briefly.
4. Press 'Start/Stop' again to pause the timer.
5. Press 'Reset' (often on the bottom right) while the timer is paused to clear the stopwatch to zero.

Mantentzea

Erlojua garbitzea

Zure erlojuaren itxura mantentzeko:

• Garbitu erlojuaren kaxa eta uhala zapi leun eta apur batekinamp oihal.
• For stubborn dirt, use a mild soap solution, then wipe clean with a damp zapi eta ondo lehortu.
• Avoid using abrasive cleaners or solvents, as these can damage the watch's finish.

Bateria ordezkatzea

The Zippo 45016 uses a product-specific battery. When the display becomes dim or the watch stops functioning, the battery may need replacement. It is recommended to have the battery replaced by a qualified watch technician to ensure proper sealing and functionality.

Arazoak konpontzea

Zehaztapenak

• Modelo zenbakia: 45016
• Marka: Zippo
• Mugimendua: Kuartzo digitala
• Bateria: 1 product-specific battery (included)
• Produktuaren neurriak: 25.4 x 4.9 x 0.64 cm
• Pisua: 54.43 g
• ASIN: B004WMEY9K

Bermea eta Laguntza

For warranty information, please refer to the warranty card included with your purchase or visit the official Zippo website. If you require technical assistance or have questions not covered in this manual, please contact Zippo customer support through their official channels.