Sarrera
This manual provides comprehensive instructions for the installation, operation, and maintenance of the Hunter 99179 Original Ceiling Fan Remote Control and Canopy Kit. This kit is specifically designed to enhance the functionality of Hunter "Original" series ceiling fans by adding remote control capabilities for fan speeds and lighting.
The kit includes a remote control unit and a canopy designed to house the receiver. It integrates with your existing two-wire fan setup, offering convenient control over three fan speeds and the fan's light fixture.
Segurtasun informazio garrantzitsua
- Segurtasun elektrikoa: Always disconnect power at the circuit breaker or fuse box before attempting any installation, maintenance, or repair. Failure to do so can result in serious injury or death.
- Bateragarritasuna: This kit is designed for use BAKARRIK with Hunter "Original" series ceiling fans. It is not compatible with other fan models or brands.
- Downrod Requirement: Installation requires a downrod of 12 inches or longer (sold separately). The receiver unit is designed to fit within the canopy, which necessitates sufficient space provided by a longer downrod.
- Instalazio profesionala: If you are unfamiliar with electrical wiring or ceiling fan installation, it is recommended to consult a qualified electrician.
- Tokiko kodeak: Ensure all installation procedures comply with local electrical codes and ordinances.
- Produktuaren osotasuna: Ez aldatu produktua eta ez erabili aurreikusitako erabileratik kanpoko helburuetarako.
Paketearen edukia
Instalazioa hasi aurretik, egiaztatu osagai guztiak daudela:
- Urruneko Aginte Unitatea
- Urruneko hargailua
- Canopy (for receiver housing)
- Mounting Hardware (screws, wire nuts, etc. - specific items may vary)
Image: A Hunter ceiling fan, representative of the type of fan compatible with the 99179 remote and canopy kit.
Konfigurazioa eta Instalazioa
Follow these steps carefully to install your Hunter 99179 Remote Control and Canopy Kit:
- Potentzia deskonexioa: Before starting, turn off the electrical power to your ceiling fan at the main circuit breaker or fuse box.
- Sarbide kableatua: Carefully lower the existing canopy from your Hunter Original ceiling fan to expose the wiring connections.
- Remove Old Receiver (if applicable): If an old receiver is present, disconnect its wiring and remove it.
- Hartzaile berria instalatu: Connect the new remote receiver's wires to the corresponding fan and household wires. Ensure all connections are secure using wire nuts. The receiver is designed to fit within the new canopy.
- Kanopiaren posizioa: Carefully tuck the wired receiver into the new canopy. Ensure no wires are pinched.
- Kanope segurua: Mount the new canopy securely to the fan's mounting bracket. Confirm that the downrod is at least 12 inches long to accommodate the receiver within the canopy.
- Berrezarri boterea: Once installation is complete and all connections are secure, restore power to the ceiling fan at the circuit breaker.
- Parekatu urruneko: Follow the instructions provided with the remote control unit to pair it with the newly installed receiver. This typically involves pressing a button on the remote within a short time after restoring power.
Oharra: The new canopy is designed to accommodate the receiver. Some older Hunter Original fan mounting plates or downrods may not be compatible with the new canopy's dimensions. Verify fit before final installation.
Funtzionamendu-argibideak
Your Hunter 99179 remote control provides convenient operation of your ceiling fan and light:
- Fan abiadura kontrola: Use the designated buttons on the remote to cycle through three fan speeds (Low, Medium, High) or to turn the fan off.
- Argiaren kontrola: Use the light button to turn the fan light on or off. Some remotes may also support dimming functions if your fan and light kit are compatible.
- Bateria ordezkatzea: If the remote control stops responding, replace the batteries. Refer to the remote's specific instructions for battery type and replacement procedure.
Mantentzea
To ensure optimal performance and longevity of your Hunter 99179 kit:
- Garbiketa: Periodically wipe the remote control and canopy with a soft, dry cloth. Do not use abrasive cleaners or solvents.
- Bateria egiaztatzea: Replace remote control batteries as needed to maintain reliable operation.
- Kableatuen ikuskapena: Annually, or if issues arise, ensure all electrical connections within the canopy are secure and free from corrosion. Always disconnect power before inspection.
Arazoak konpontzea
If you encounter issues with your remote control and canopy kit, refer to the following common solutions:
| Arazoa | Kausa posiblea | Irtenbidea |
|---|---|---|
| Urrutiko agintea ez da erantzuten / Haizagailua edo argia ez dabil |
|
|
| Canopy does not fit / Receiver cannot be housed |
|
|
| Beste gailu batzuen interferentziak |
|
|
Zehaztapenak
- Modelo zenbakia: 99179
- Fabrikatzailea: Hunter Fan Company
- Produktuaren neurriak: 6 x 6 x 7 hazbete inguru
- Elementuaren pisua: 2.35 kilo inguru
- liburukiatage: 120 Volt
- Energia iturria: Hari-elektrikoa
- Materiala: Metala
- Ziurtagiria: ETL zerrendatua
- Erabilera: Ceiling fan remote control and canopy accessory
- Ezaugarri berezia: Heavy Duty construction
- Gailu bateragarriak: Hunter "Original" series ceiling fans
Bermearen informazioa
No specific warranty description is provided for the Hunter 99179 Remote Control and Canopy Kit in the product details. For warranty inquiries, please contact Hunter Fan Company directly or refer to the documentation included with your original Hunter "Original" ceiling fan.
Bezeroarentzako Arreta
For further assistance, technical support, or to inquire about parts, please visit the official Hunter Fan Company webwebgunean edo jarri harremanetan bere bezeroarentzako arreta zerbitzuarekin.
Hunter Fan Company Webgunea: Bisitatu Hunter denda Amazonen
